Your SRS light should turn on each time you begin your car, and turn turn off if every little thing is functioning properly. One SRS light that stays on suggests a difficulty with your main SRS unit, airbags, or with the power supply.

You are watching: 2001 honda accord srs light reset


This article uses to the Honda Accord (1990-2002).

The Supplemental Restraint mechanism (SRS) light stays on as soon as it is indicating a problem with your car"s SRS computer, airbags, the steering wheel, or the driver"s seat. A problem with the car"s computer often indicates that the light won’t reset top top its own. The light likewise can suggest that something–such as your gauge swarm or SRS harness–is unplugged. Also, store in mind that simpler troubles like a weak or low-voltage battery might cause the SRS light to continue to be on. You can reset the light on her own; however, this won’t resolve any underlying issue(s). Come properly find out what the cause is, you might want to take it it come an auto shop or the auto dealership. However if you just want that to revolve off, follow this DIY steps.

*
Figure 3. Affix terminals that the two-pin organization connector to run a diagnostic check on her SRS unit.

Step 3 – change SRS unit

A faulty SRS unit can explain why her SRS light won"t remain off, also after you try resetting it. Before replacing the whole unit, make certain all connections are tight. Loosened connections can reason the SRS light to remain on as well, and also tightening the relationships can often resolve the issue.

See more: Kingdom Hearts 1.5 Proud Mode Questions, Kingdom Hearts: Proud Mode Tips

Disconnect your battery, and also wait in between three to 5 minutes prior to replacing her SRS unit.The SRS unit is an installed on the floorboard near the firewall, which is behind the share radio. To accessibility the unit, remove the center console and also two next panels. Over there is one screw and also one clip ~ above the driver’s side. There are two clips top top the passenger"s side.Use a T30 Torx screwdriver to remove the 4 screws stop the SRS unit in place. There space two screws top top top and two ~ above the side. Be cautious not come drop any of this screws right into the AC vents.Before unplugging the unit, make sure all relations are tight. A loose harness connection can cause the SRS irradiate to revolve on, for this reason tightening the link may resolve the worry without having to download a brand-new one. In ~ this point, reconnect the battery to examine if the light turns off. If the connections are tight and also the SRS light continues to be on, disconnect the battery and continue on.Unplug the 3 connectors come the SRS unit. Plugin the brand-new unit and also secure that in ar with the 4 screws. Replace the facility console, and also the two side panels.Reconnect the battery and turn the ignition on. The SRS light should now it is in off.